Single Row Four Points Contact Ball Bearing for Wide Range Excavator, Four point contact ball slewing bearing excavator slewing bearing a good replacement slewing ring bearings used on Komatsu, Hitachi, Kobelco, Caterpillar, Hyundai and so on.Slewing bearing is widely used in construction machinery, especially excavator. The feature of excavator slewing bearing is with hardened inner gear and the common diameter ranges from 1m-2m.
As the slewing bearing is mainly bear axial load and tilting moment during excavator is working, slewing bearing is crucial to the long service time of excavator. So we must attach much importance to the quality and maintenance of the bearing.First, in order to provide good quality slewing bearing, Xuzhou Wanda Slewing bearinb uses high quality forgings, balls, spacers and seals; and during production, we strictly control production process and precision.Second, regular and good maintenance of slewing bearing is also very import, there are following six steps to save slewing ring bearings.
At a glance: six steps to save slewing ring bearingsMore than 96% of slewing ring failure could be avoided by following simple maintenance tips.Grease regularly.Apply a liberal shot of extreme-pressure grease to the fittings around the bearing's circumference at intervals recommended in the operator's manual.Purge with grease.Pump grease into the bearing until you see old grease squeeze past the seal. Purged grease can help carry any contaminants out of the bearing.Inspect the grease.Rub some of the purged grease between your thumb and forefinger. If you see or feel grit or metal chips in it, there may be a bearing problem.Honor load charts.Even slight overloads can dimple the bearing race. One 1/1000 of an inch depression will worsen with subsequent loads and cause eventual failure.Avoid repetitive, heavy loads.Lifting with the boom and undercarriage in the same position, such as repetitive curbside digging with an excavator, can put a dimple in the bearing race close to the uneven load. If possible, change the angle of approach from job to job.Predict failure and repair the bearing.If the turning torque of the bearing increases substantially, or if you notice a clicking.