Views: 19 Author: Tina Chen Publish Time: 2018-09-06 Origin: Site
Single row ball slewing ring bearing must be installed in a horizontal position or on specially built incline cradles that support the ring structure appropriately. Any ovality so developed must be removed during installation.
Single row ball slewing ring bearing usually have lifting holes for eye‐bolts to assist lifting in the inner and outer rings.Please check the weight of the ring to ensure slings and/or chains are of sufficient capacity!
Shock loads, especially in the radial direction, must be avoided as this may damage the raceways.
If stacked on a pallet then care must be taken not to dislodge seal strips or grease fittings during movement. Wooden or rubber spacers would be of benefit between each bearing. External gear teeth (especially) should be protected from any impact damage.
As supplied slewing rings are generally packed for storage in a covered store and for a period not exceeding 6 months. Light surface corrosion can usually be removed from exterior surfaces – and it is more important that the raceways are well greased and rust free. Standard commercial solvents can be used to degrease the slewing ring if necessary.
In extreme cases after long term storage bearings may need professionally reconditioning before installation.When unwrapping, care must be taken not to cut and damage the integral seals.
The supporting surfaces must have a flat machined surface and be rigid enough to eliminate torsional buckling under load that would affect the smooth operation of the single row ball slewing ring bearing. The thickness of the supporting plates should be no less than that indicated below – which is offered as a rough approximation only.
Home | About Us | Products | News | Application | Support | Contact Us